Highlights: A study this summer found that using a single gas stove burner on high can raise levels of cancer-causing benzene above what’s been observed from secondhand smoke.
A new investigation by NPR and the Climate Investigations Center found that the gas industry tried to downplay the health risks of gas stoves for decades, turning to many of the same public-relations tactics the tobacco industry used to cover up the risks of smoking. Gas utilities even hired some of the same PR firms and scientists that Big Tobacco did.
Earlier this year, an investigation from DeSmog showed that the industry understood the hazards of gas appliances as far back as the 1970s and concealed what they knew from the public.
It’s a strategy that goes back as far back as 1972, according to the most recent investigation. That year, the gas industry got advice from Richard Darrow, who helped manufacture controversy around the health effects of smoking as the lead for tobacco accounts at the public relations firm Hill + Knowlton. At an American Gas Association conference, Darrow told utilities they needed to respond to claims that gas appliances were polluting homes and shape the narrative around the issue before critics got the chance. Scientists were starting to discover that exposure to nitrogen dioxide—a pollutant emitted by gas stoves—was linked to respiratory illnesses. So Darrow advised utilities to “mount the massive, consistent, long-range public relations programs necessary to cope with the problems.”
These studies didn’t just confuse the public, but also the federal government. When the Environmental Protection Agency assessed the health effects of nitrogen dioxide pollution in 1982, its review included five studies finding no evidence of problems—four of which were funded by the gas industry, the Climate Investigations Center recently uncovered.
Karen Harbert, the American Gas Association’s CEO, acknowledged that the gas industry has “collaborated” with researchers to “inform and educate regulators about the safety of gas cooking appliances.” Harbert claimed that the available science “does not provide sufficient or consistent evidence demonstrating chronic health hazards from natural gas ranges”—a line that should sound familiar by now.
It’s been time to switch to induction stoves for a long time now, they are basically better in every way that matters.
How are they with temperature regulation? I think that’s a big holdback for a lot of people. A gas burner gives consistent heat output at the set level, while an electric burner cycles on and off, resulting in a wider temperature range.
ETA: Wow, WTF? Downvoted for asking a legit question. Are we Reddit now?
They’re probably more consistent than gas. Provided your cookware isn’t moved on the surface, they provide a constant energy output that is a simple linear equation of energy in - losses = energy out. Period. Induction elements “cycle” on and off – hundreds or thousands of times per second. They don’t work like a radiant electric stovetop at all. There is no human perceptible duty cycle.
Fancier models like Bosch and some of the new GE Profile/Cafe ones can even wirelessly communicate with special cookware that has a temperature sensor built in, and deliver you absolute parametrically controlled temperature output at a specific temperature down to the degree, with computer controlled precision. It doesn’t get any better than that.
One thing I don’t like about induction is that I don’t feel like a cool chef tossing the pan. I have to just let it sit there, and if I pick the pan up it beeps at me and turns off. Plus there’s no fire.
It’s safer but definitely way less fun.
Mine will wait around five seconds before beeping at me. That usually gives me enough time for whatever flamboyance I’m attempting.
But you’re right that moving the pan away from the surface basically disconnects it from the heat source. Mine will noticeably warm a pan from about half an inch away, but no further.
I wish I could test drive a stove before I buy it. I’ve just been using a cheap induction cooktop and it’s so bad I’m sure a full-size stove would be better, but I don’t want to drop a couple grand plus rewiring my house to find out the stove I bought sucks as bad as this cooktop.
But damn can it boil water fast.
If you’re paying a couple of grand for one you’re probably looking at a premium unit. Or your local dealer is overcharging. The Frigidaire FCFI3083AS lists for $1199, a lot of retailers have it for less. Samsung’s model is a bit cheaper still, but don’t buy a Samsung appliance.
What don’t you like about the cooktop? And what brand is it?
They sell single burners. That use a 110. You can use it for water boiling and use the range for bugger meals
I feel like there’s gotta be a costco-like store that does that. I certainly would want the same thing.
Must be hard to braise.
Sounds like you have an old version of induction. There is no beeping on mine when doing that at all.
See unfortunately what you’re describing here are good induction stoves, which is not the majority of what is on the market.
I’ve seen far too many of the bad kind, with duty cycles measured in the tens of seconds. Your 7/10 on the dial could be - like a non-inverter microwave - something in the neighbourhood of 7 seconds on / 3 seconds off. At that point they can actually be worse to use than old halogen glass cooktops, which at least remain hot during the off part of their thermostat’s cycle.
This is not even just cheap no-name crap either, have witnessed it with big-name-brand in-bench stovetops with four-figure pricetags.
If you’re doing something like poaching eggs (which typically calls for a wide, flat pan), you’ll actually see the water starting and stopping boiling in a cycle as it switches. Absolutely terrible.
I have a le cheapo Frigidaire, and mine definitely doesn’t do that. I also have a Summit tabletop single burner induction hot plate kicking around, which I think cost me all of $130 and came with three pans in the box. It doesn’t do that, either.
If you’ve got a recent model that does have a long on-off duty cycle like that, you should name and shame so people know to avoid it. People buying that kind of thing and being turned off by it is just going to slow down the course of progress, here.
Induction has instant temperature control, combined with the possibility of having lower temperatures than gas allows for.
Additionally, there’s no temperature leakage into the room, nor any particles from combustion.
They are perfect at temperature regulation. I have a little 120v unit that even has a hold @ temperature function. Goes as low as 180 and I think as high as 500°
Remember induction heats the pan directly via induction and thus requires cookware that a magnet can stick to. Otherwise faster, more efficient, easy to control
They also boil water faster than consumer stoves. My pans are no longer sticky with the un-ignited gas residue. Baking is so much more even as well. I cook the same amount and my power/gas bill is lower than before. Lots of benefits.
Baking in electric is better than gas because one of the combustion products is water, which reduces the drying effect of baking.
It really depends on which induction burner you have. I’ve got a 120v one with a “temperature hold” function. It varies +/- 30 degrees. Trying to hold chocolate or a cream sauce at a specific temperature always results in burning. Maybe I have a shitty one, but it just cycles on and off at full power at set intervals, and it’s nowhere near the consistency I get out of my gas stove.
I really, really hope the stoves out there don’t do this sort of thing, and actually just run the induction constantly at reduced output instead of just cycling on and off. But the cooktop is still perfect for boiling huge amounts of water, or getting cast iron rocket-hot for searing.
Always have been.
And as others may have said, induction stoves hold perfect temperature, but also require you to use more substantial steel pots and pans to begin with. As such, they won’t suffer from poor temperature modulation like older resistive electric stoves with cheap aluminum pans would.
Just got rid of my gas stove and got induction. I will never cook with gas again. They have way faster heating and temperature control. Any one who says different hasn’t used induction.
A lot of other comments in this chain are getting a single downvote so far.
It’s ok Big Gas/Oil, we know it’s you.
All electric are fine. There is no discernible difference by the time it gets to the food. Like I had to be academically informed that this on/off even happened, I had no idea. This is such a ridiculous fake concern that’s been created.
I’m sorry, it is unbelievable to me that anyone who has done a good amount of cooking on both gas and old-style electric stoves would say they are equivalent. It simply tells me you do not have adequate experience, or are not observant enough to notice.
I don’t mean this as a personal attack. It’s just…this isn’t an opinion. Gas is dramatically more responsive and precise for heat control. This is objective. If the way you cook does not leverage fine heat control or require quick changes to heat levels, then no you will not notice.
But the difference is stark and noticeable for someone who wants and uses this level of precision.
Out of curiosity, what are you cooking that requires quick changes to heat level?
Completely fair question.
Tons of things require this. Eggs are much easier this way. Anything that needs to be brought to a boil then dropped to a simmer. Anything that needs to not be overcooked but still needs to hit temp. Fish and chicken come to mind. It also just enables fine adjustments while cooking. If I am searing something but realize I crowded the plate and things have started steaming instead, it’s easy and fast to turn the heat up one notch.
Granted some of this comes down to what kind of pan you have too. I cook a lot with a carbon steel pan and it’s very quickly responsive to heat changes. I have a set of all-clad pans and they also respond relatively quickly. But like, my cast irons obviously don’t so it’s a bit moot for them.
Compared to coil definitely, but not if we are talking induction. Induction is as responsive as gas for heat control. Of course noone should be buying electric coil stoves in this day and age.
I’ve heard that from people and I’m eager to eventually have a chance to try one. Our gas stove is under 10 years old and works fine, so a new induction range isn’t really on the horizon for us financially.
But I’m definitely interested to try one.
Gas fanatic freakout exhibit A. Has to change the point being discussed and then yes attack. No point discussing because this will repeat.
Sorry if it sounded like a freak out. That wasn’t intended.
How did I change the point? You said all electric ranges are fine. I contend they are not and tried to support that argument. Happy to hear your interpretation of what I said beyond dismissing it.
And again what I said wasn’t intended as a personal attack on you. But if the argument is that electric and gas are equivalently effective at cooking, that’s a difficult discussion to have because it’s coming from a place of factual inaccuracy.
It might come from those cheap portable models. I tried one my mom had and the cycles were very obvious. It was difficult to do anything where I had to hold a temp, even doing a simple simmer was hard because it would go from boiling to nothing repeatedly. Things constantly burned on it due to poor temp regulation. I know it was a shitty model and I expect full size models to be much better, but it was a concern of mine as well.
I do hope to pick up an induction within a year or two. Can’t really afford it at the moment though.
That mostly has to do with your cookware. I’ve got an older electric unit with really distinct power cycling like you say and it’s only a problem with cheaper aluminum pans. My good laminated steel pans and cast iron are perfectly consistent because they have a lot of thermal mass so they retain the heat and even out the power cycles into a nice average temperature.
Freaking out because some idiot downvoted you. Are we Reddit now?
Consistent heat to that level doesn’t matter outside of VERY specific use cases like tempering a ridiculously small amount of chocolate with very little water in the double boiler setup. Oh, and you have like pure aluminum pans, I guess.
Because also? Gas stoves aren’t as consistent as people think. Yes, we assume they are because we can see the fire. But various impurities in the line, air in the system, etc and you still get minor sputtering and fluctuations.
All of which… almost never matters. Because even when you are doing the most delicate of baking work: You tend to have a double boiler set up so that the water can maintain the heat during these fluctuations.
That is not how induction works. The big holdback for people is ignorance about what induction even is. Temperature regulation is instant same way as it is with gas.